IEC 61646 PDF

NATIONAL FOREWORD. The Saudi Standards, Metrology and Quality Organization (SASO) had adopted the IEC “Thin-Film Terrestrial Photovoltaic (PV). IECEE Certification & Testing | IEC Standards | IEC | General Information. PDF | Wet leakage is one of the most frequent failure causes in the IEC test sequences [1]. Although the wet leakage test procedure is.

Author: Akinozshura Akigore
Country: Mexico
Language: English (Spanish)
Genre: Love
Published (Last): 18 April 2014
Pages: 335
PDF File Size: 9.15 Mb
ePub File Size: 10.49 Mb
ISBN: 236-4-15660-514-4
Downloads: 64650
Price: Free* [*Free Regsitration Required]
Uploader: Dokus

The IEC standard specifies the criteria for the design qualification and type approval of concentrator photovoltaic modules and assemblies suitable for long-term operation in general open-air climates. An additional test takes the degradation behavior of amorphous silicon due to temperature and irradiance exposure into account.

The second part consists of the requirements for testing. Moreover, most certification bodies do not perform regular check ups after the certification has been issued, leaving eic theory and praxis many opportunities for bad manufacturers to cut quality corners while on paper holding that certification.

It is crucial to use Ief modules tested against salt mist corrosion certification in case the modules shall be installed near coasts or used for maritime applications. Then only the certification should be confirmed.

  EARTH MATERIALS KLEIN PHILPOTTS PDF

Nevertheless, depending on where you want to install your panels, the certifications may still be required as per your national requirements or for example in order to apply for FIT. I have check IEC, but did not find the right information.

Or do I also need IEC ? Thank you very much. Niclas is absolutely correct. Photovoltaic PV module safety qualificationwhich was later issued as the European standard EN almost similar.

IEC Standard – Home

I am a test engineer in SPV lab. Solar system installers who do installation in areas with heavy snow should definitely use products with an increased load capacity: The certifying authority should conduct the same tests on representative samples after the uec production has started to confirm the quality on the commercially produced item.

IEC tests at the time of applying for certification. A special certification for Concentrator PV CPV modules is necessary, because the high concentration of the solar irradiance through lenses or mirrors causes higher stress on the equipment. This has been included in the IEC ed.

  ALSTOM CONFIDENTIAL FILETYPE PDF

When I buy a solar panel with IEC certification, does it mean the lec of the solar panel is good? When testing, the prepared and submitted modules undergo HALTs highly accelerated life tests that are not representative of standard real-world conditions.

Photovoltaic Solar Testing Specifications

ieec Basically, certifications per se do not tell much about the quality of a module. This includes all forces of nature:. When installing solar panels in areas with heavy snow, an increased load capacity of Pa is advisable.

Its purpose and ic. Solar installers that are operating in a highly corrosive atmosphere such as near the sea, the resistance of PV panels against the corrosive effects should be checked. Nowadays many solar manufacturers produce according this requirement.

For photovoltaic systems it suggests total insulation, which requires a 616646 insulation of the PV modules according to Safety Class II on the basis of the following requirements:.